Nexpart allows you to have as many parts suppliers set up as you wish. Each Nexpart integration is separate and will launch a different portal for each vendor. Depending on the Nexpart vendor(s) you choose and if they have ACDelco Connection, you can not only add parts to your cart, but add Mitchell labor times as well that can be imported into Tekmetric.
Watch the setup and ordering video here.
We've separated the instructions below out into two sections:
Step 1 - Setup Nexpart Accounts
- Call or email your existing suppliers that are offered through Nexpart (see table below for common vendors list and associate contact information).
- Ask for your Nexpart credentials for Tekmetric. Once the username and password are given to you, write them down.
-
Notes:
- You will get different credentials for each part supplier account you have.
- The processing time for each vendor can range from 5 minutes to 5 days.
- This list is not fully exhaustive. If you do not see one of your suppliers here, you can contact your supplier representative to see if they have a "Nexpart" / "WHI Solutions" connection.
Step 2 - Integrating Nexpart Accounts with Tekmetric
Connect your part suppliers to Tekmetric via Nexpart
- Click the Shop Settings section on the bottom of the left menu bar.
- Click the tab Integrations.
- Click Manage from the Nexpart integration box.
- Click New Vendor.
- Enter Vendor Name.
- For Nexpart NexLink Login, type in the Username that was given from your part supplier.
- For Nexpart NexLink Password, type in the password that was given from your part supplier.
- Click Save.
Disconnect Nexpart
- Click Vendors section on the left menu bar.
- Click on the vendor that you would like to remove that is integrated with Nexpart.
- Scroll to bottom of page.
- Click Delete Vendor.
- A window will appear, click Delete.
