GODEX Printer Configuration

To print lube stickers from your GODEX printer, you'll need to complete the following steps. Often, there is a bit of tweaking required depending on the exact printer and stickers your shop uses. We recommend starting and then making small adjustments until the ideal print result is found. This article will review the following:

Adjustments to Printer Hardware Settings

Open the printer hardware settings or preferences  (This is outside of Tekmetric in your computer settings). Configure the settings to reflect the following:  

• Name: Tekmetric (1.5in X 2.0in)
• Orientation: Portrait 180
• Horizontal Offset: 0.00in (located in Advanced Options) 
• Vertical Offset -0.75in (located in Advanced Options)

Adjustments to Tekmetric Printing Settings

Once hardware settings have been changed, navigate to an open RO in Tekmetric. You'll need to make sure mileage is entered on the RO in the top right corner first. Then click the printer icon and choose Print Oil Sticker. Adjust the sticker height and width ratio. Start with the below settings and make small adjustments as necessary depending on your sticker size. 

Printing the GODEX Sticker

• Destination: GODEX RT200 (or other name for printer) 
• Pages: All
• Copies: 1
• Paper size: 2 X 4
• Pages Per Sheet: 1
• Scale: Fit to paper